Pancrete Coating

Product Description

Leaks and holes in condensate pans can be covered with duct tape or sheet metal and then sealed over with pancrete to make the pan like new again saving you time and money in pan replacement costs.

Not affected by coil cleaners

Click here for larger or smaller size cans

One gallon will cover about five square feet of surface area.

We recommend the use of Clean Bond to prep surfaces before applying Pancrete or V570. Click Here to Purchase

Use Our Pan Hole Filler before pancrete for Larger Holes Click Here to purchase

After a few years your condensate pans will become corroded, and surfaces become irregular.

Once galvanizing is gone, rust spreads rapidly, eventually ruining the pan. This causes you expensive replacement and equipment downtime. Now there is a solution to the problem and prevention for it.

Applying Pancrete to your HVAC condensate pans, makes the surface like new again, providing a tough surface that is chemically resistant to concentrated coil cleaners. It automatically fills in irregular surface characteristics, providing a smooth, chemically resistance surface for the condensate pan.

Leaks and holes in condensate pans can be covered with duct tape or sheet metal and then sealed over with pancrete to make the pan like new again saving you time and money in pan replacement costs.

Additionally, some pans develop low spots where water can stagnate. Pancrete will form a level pan, so that water goes where it should - down the drain.

After pouring, unit may be returned to service in as little as 4 hours.

New condensate pans should be coated to remove dead spots on the pan surfaces, and protect the pan's surface from corroding. Applying Pancrete to a new pan will extend the life of the pan dramatically and perform better than a factory installed original galvanized pan.

Pancrete is more than a "Pan In A Can" - it's amazing!